Hog Slat Inc. Newton Grove, NC USA February 2024 7 Wind Storm Fans Installation The following guide lines should be followed regardless of installation method. Any deviation from these parameters will void the warranty. TO MOUNT FAN TO MOUNTING STAND USE SUPPLIED HARDWARE. THE 3/8” (LARGER) BOLT, WASHERS, AND NUT SHOULD BE USED ON THE LARGER HOLE WITH THE MOUNTING BRACKET INSTALLED BETWEEN THE MOTOR MOUNTING TABS. THE 1/4” (SMALLER) BOLTS, WASHERS, AND NUT SHOULD BE USED ON THE SLOTS AND SMALLER HOLE IN THE MOUNTING STAND. THE ORDER SHOULD BE BOLT, WASHER, MOTOR MOUNT, MOUNTING STAND, MOTOR MOUNT, WASHER, AND FINALLY THE NUT. 1. The capacitor housing on the motor should always be oriented upward towards the ceiling and the mounting stand should always be perpendicular the ground or ceiling (VERTICAL). Mounting the stand in any other orientation is not permissible. 2. If the fan is tilted the angle should not exceed 50 degrees.
RkJQdWJsaXNoZXIy MTA3MzU=