Hog Slat Inc. Newton Grove, NC USA September 2020 2 Feed Tank System Accessories Center Punch and drill (18) 3/8” diameter holes in Tank at locations on Template guide. A new, sharp drill bit is recommended to minimize burring. Using a Jig Saw with fine tooth metal cutting blade; cut out the 5-1/4” x 3-1/2” (127.3mm x 90.5mm) access hole using inside line of Template as a guide. Remove any burrs. Important: Do Not use Grinder or Cutting Torch to cut access hole as it will damage metal galvanizing resulting in premature bin corrosion. Remove Template and discard. Apply supplied caulking along hole pattern on Bin cone. Make sure caulking is on both sides of holes. Make sure corners are included. Assemble Slide Door (GST-AC3010) to Slide Plate (GST-AC3014) as indicated in Figure 1. Apply supplied caulking along top and side hole patterns on Slide Plate (GST-AC3014). Make sure caulking is on both sides of holes. Make sure corners are included. Assemble three components to tank with supplied screws. Nuts should be on outside of tank. Bolts should be tightened sufficiently to compress caulk and tighten bolts and nuts. Assemble Hopper Chute and Locking Bracket as indicated in Figure 1. Note that angle of Chute is adjustable to desired angle. Locking Bracket should be adjusted to line up with hole in Slide Door such that a pad lock can be placed through both to secure Hopper Valve Chute. Assemble Blue Handle to Slide door with Bolt and Nut and check function. Warning: Keep Arm out of tank during routine use. Collapsing Material can cause serious injury. Figure 1 Figure 1 Item Part Number Description Quantity 1 GST-AC3014 Slide Plate 1 2 GST-AC3010 Slide Door 1 3 GST-AC3008 Shroud 1 4 GST-AC3009 Chute 1 5 GST-AC3007 Handle 1 6 608089 Bolt-Hex 5/16-4 1 7 605800 Washer- 5/16 2 8 60681 Nut - 5/16 1 9 HS714 Bin Bolt-Truss Hd 5/16-3/4 20 10 HS722 Nut - 5/16 Serrated Flange 20 11 GST-AC3006 Locking Bracket 1
RkJQdWJsaXNoZXIy MTA3MzU=