Hog Slat Inc. Newton Grove, NC USA January 2021 REV A9 4 Pit Scraper Systems Set scraper cycle times: 1. To set the beginning of a cycle, pull inward the tab that corresponds with the time of day the cycle is to start. 2. Set “OFF” time by making sure the next tab in sequence is “Down or Outward”. 3. Any rest period between cycles will be represented by the tabs being “Down or Outward”. 4. Repeat cycle set up by pulling inward tabs that correspond with time of day the cycle is to start. A maximum of 48 cycles is available in a 24 hour period for barn lengths of less than 375FT [114M]. For barn lengths greater than 375FT [114M], Two (2) tabs will be required for each “ON” and “OFF” cycle since it will take longer than 15 minutes (length of time of one tab) to travel the distance of the barn. A maximum of 24 cycles will be available. 24HR TIMER Programming Tabs Pull inward for “ON” Press outward for “OFF” Tabs align with time of day in a 24 hour period Time set by rotating center section clockwise or counter-clockwise FIGURE 1
RkJQdWJsaXNoZXIy MTA3MzU=