Hog Slat Inc. Newton Grove, NC USA January 2021 REV A9 8 Pit Scraper Systems Installation: 1. Refer to Figure 4 for typical layout of pit scraper and Auto Pit Scraper Control enclosure. 2. Control enclosure should be mounted in a convenient location and in close proximity to “Pit Scraper Power Unit”. 3. All wiring should be enclosed in NON-METALLIC liquid tight conduit and connector fittings. 4. Route all external wiring into bottom of enclosure where possible to prevent water entering enclosure. 5. Care should be taken when drilling holes into enclosure to prevent damage to wires or other components. 6. Properly ground system including limit switches mounting in pits. TYPICAL LAYOUT - FIGURE 4 To ensure proper operation of Limit Switches, mounting location must be located in the pit opposite of the waste collection end. This will prevent waste from prematurely activating Limit Switches.
RkJQdWJsaXNoZXIy MTA3MzU=