Hog Slat Inc. Newton Grove, NC USA APRIL 2025 REV A1 10 Ventilation System 9. Close the front door and set latch on the enclosure. Re-connect the power to the controller. On initial power up the controller will require minimum set up before activating the controller for operation. This is similar to setting DIP switches except the set up occurs through the touchscreen. It is important to perform the initial set up so that the operation of the controller is predictable. Simply follow the instructions below found in SECTION 9. NOTE: The controller by default is set up with all cooling stages (no heat). If you press the activation icon before you have performed the minimum setup in SECTION 9, the controller will default to one probe input, no heat, no mist and all stages will be cooling. You can easily change any set up at any time. SECTION 6 & 7: WIRING INSTRUCTIONS: Reference Section 5 relative to secondary power supply connection and ribbon cable installation. No other connections are required. SECTION 8: SWITCHING LANGUAGES The controller can toggle between English and Spanish language on most all screens. Simply locate the icon on the page to switch to Spanish. Locate the icon to switch to English. The icons do not always appear in the same location but in most cases they will be located next to the yellow function button or lower left corner of the screen.
RkJQdWJsaXNoZXIy MTA3MzU=