Hog Slat Inc. Newton Grove, NC USA May 2024 REV IR 8 Ventilation System 4. Carefully open the front door enclosure as far as possibly and pull the door hinges toward you until they have released from the pins in the enclosure mounted on the wall. 5. Place the new HSVC1024-2C5A assembly and align the hinges with the existing mounted enclosure. With them align carefully push the hinges onto the pins until they snap over the pins. 6. Take end of the ribbon cable and align the connector with the connector on the bottom board in the same location as the original ribbon cable was removed. When it is aligned, slowly press down in the center of the connector until the side latches fold up and lock the connector in place.
RkJQdWJsaXNoZXIy MTA3MzU=