Hog Slat - HSVC1024-2C5A Replacement Top Board For Ventilation Manual

Hog Slat Inc. Newton Grove, NC USA AUG 2025 REV A4 9 Ventilation System 6. Take end of the ribbon cable and align the connector with the connector on the bottom board in the same location as the original ribbon cable was removed. When it is aligned, slowly press down in the center of the connector until the side latches fold up and lock the connector in place. 7. The new touchscreen requires an auxiliarly power supplied (included) The screen will not turn on until this is connected. Connect the RED lead to the AUX (+) terminal and the BLACK lead to the AUX (–) terminal found on the back of the newly installed front door assembly. 8. Connect the BLUE wire from the auxiliarly power supply to the Neutral or L2 input on the bottom board. Connect the Brown wire from the auxiliarly power supply to the L1 input terminal. If supply wire going to controller is 12 AWG, place brown and blue wires underneath the same side of the clamp as the 12 AWG wire. If the smaller wires are on the opposite side of the terminal wire clamp, the small brown or blue wires will be left loose and will not be a stable connection.

RkJQdWJsaXNoZXIy MTA3MzU=