Hog Slat Inc. Newton Grove, NC USA July 2024 REV A5 14 Ventilation System 12. CURVE SET POINT: Shows current value of the set point from the Temperature Curve when activated. 13. CONTROLLER ID NUMBER: When the controller is connected to a PC interface network each controller is assigned an ID number after initial SEARCH function has been performed. The ID number that has been assigned to the controller will be displayed on the IDLE SCREEN in this location. ========================================================================================= 14. SETTINGS PAGE: Press SETTINGS ICON to launch SETTINGS page. 14A. EMPTY BARN OPERATION: Option to be used when barn is empty. Minimum ventilation fans run at minimum speed and minimum ventilation cycle. Heaters (if assigned) will operate to maintain above EMPTY BARN temperature. Press ACTIVATE button to launch operation. 14B. STAGE OFF DELAY (seconds): For stages 3-6. Provides additional delay prior to stage turning off. Helps prevent sudden stage changes in case temperature sensor is near door for example that might cause change in temperature when opened. The OFF delay may allow stage not to change states for the temporary change. Set to zero if no delay is required. 14C. TEST PANEL: To aid in set-up and to verify output stages operate as desired, press TEST PANEL button which will launch the test panel HOME screen. PRESS ACTIVATE, then adjust the SIMULATED TEMPERATURE +/- icons to simulate room temp changes versus the SET POINT. When finished press the DE-ACTIVATE button or if no activity for 5 minutes, unit will revert back to normal operation. Press EXIT to return to MAIN screen. 14A 14B 14D 14E 14F 14G PRESS “DONE” TO RETURN TO HOME SCREEN 14H 14I 14C
RkJQdWJsaXNoZXIy MTA3MzU=