Hog Slat Inc. Newton Grove, NC USA July 2024 REV A5 22 Ventilation System 18D. HEATER RUN TIME: Each heater has a resettable accumulated run timer. To reset the timer value, press the block displaying the timer value which will launch a new screen to allow user to reset each timer separately or both simultaneously. The accumulated timer is in hours: minutes and can log up to 9999:59. ================================================================== 19. MIST COOLING: Used to provide additional cooling for animals. Relay output to control misting unit(s). Mist cooling is assigned to the last cooling stage available automatically. If (2) heaters are used on Stages 5 and 6, mist cooling will be assigned to Stage 4. If heaters are used on Stage 6 only, then stage 5 will be assigned to mist cooling. If no heaters are used, then STAGE 6 will be assigned to Mist cooling. To use Mist cooling, press “ACTIVATE” icon. This will show which output has been assigned as well as launch the mist cooling cycle. During field wiring, it must be known how many heater stages will be used so that mist cooling stage assignment will be known prior to powering up controller. If you know there are 2 heaters being used, then wire stage 4 for mist cooling system. If 1 heater is being used, then wire stage 5 for mist cooling. 19A: MIST ON TIME: Set to the number of minutes for the misting system to be ON. 19B: MIST OFF TIME: Set to the number of minutes for the misting system to be OFF. 19C. MAX HUMIDITY CUT OFF: If humidity compensation is activated under Stage 1 set up, this sets the maximum relative humidity level at which time the misting system will turn off regardless if called for by temperature. 19A 19B 19C 19D 19E 19F
RkJQdWJsaXNoZXIy MTA3MzU=