Hog Slat Inc. Newton Grove, NC USA July 2024 REV A5 6 Ventilation System SECTION 3: GENERAL INSTALLATION NOTES UNIT IS NOT INTENDED FOR LIFE SUPPORT HEATING AND VENTILATION WITHOUT ADEQUATE BACKUP VENTILATION IN CASE OF FAILURE. USER ASSUMES RISK OF LOSS AND/OR INJURY IF NO BACKUP VENTILATION IS PROVIDED. Make sure that power is disconnected from system prior to servicing. Installation of this equipment and related OEM equipment should be in accordance with these instructions, OEM’s installation instructions and local codes (if applicable). Failure to follow specified instructions may cause damage to equipment and/or personal injury or death. Take special note of any Warnings or Safety Decals on the equipment and in manuals. Always wear protective clothing and any applicable Personal Protective Equipment (Safety Glasses and/or Ear Plugs) when working with the equipment. Discarded materials, equipment and boxes should be recycled in accordance with local and national codes. Note: Ventilation Controller is to be wired in accordance with all applicable local and national electrical wiring codes. All wiring sizes and fuse capacities are to be sized according to applicable electrical code specifications or other regulations. SECTION 4: SAFETY INSTRUCTIONS Read all safety messages in this manual and on equipment safety decals. Follow recommended precautions and safe operating practices. Ground all electrical equipment for safety. Ground all non-current carrying metal parts to guard against electrical shock. Always keep safety decals in good condition and replace missing or damaged decals. Pay Attention. Take the time to read and understand this as it may save you time later. Recommended operating temperature range is between 0° C and 40°C (32104°F). The control must be placed in a temperature controlled environment. It must NOT be located outside or in an area where the temperature may go outside the recommended range. Heating or air-conditioning may be required to ensure this condition is met. FOR INDOOR USE ONLY Danger. Failure to follow these instructions may create an electrical hazard and may cause damage and/or personal injury or death.
RkJQdWJsaXNoZXIy MTA3MzU=