Hog Slat Inc. Newton Grove, NC USA July 2024 REV A5 8 Ventilation System SECTION 5: MOUNTING CONTROLLER ON THE WALL It is recommended to mount the controller on an interior wall in the service area. The touchscreen should be at eye level. The enclosure measures approximately 12” x 10” x 6.5” deep. It is recommended to leave a 6” gap on each side of the controller. Open controller front cover by sliding the latch on the right side upward. Remove the plugs from each corner that covers the mounting hole as required. Mount the controller using (4) screws through the four corners as shown. Do not over-tighten as damage to enclosure could occur. SECTION 6: ELECTRICAL CONNECTIONS Warning! All wiring must be done by a certified electrician according to national and local wiring codes. The controller must be permanently connected. Disconnect power before opening the enclosure. All wiring must enter from the BOTTOM of the enclosure. You must NOT drill any holes on the side or the top of the enclosure. Doing so may allow water to enter into the enclosure and cause electrical damage to circuits. Connect conduit through provided holes in bottom of enclosure. Use the recommended fuse sizes with the appropriate agency approvals. Do NOT use fuses with a higher amp capacity as this will void the warranty and reduce the lifetime of
RkJQdWJsaXNoZXIy MTA3MzU=