Hog Slat Inc. Newton Grove, NC USA Sept. 2021 12 Feed Bins Side Wall Sheet Assembly 1. Identify the 3 lightest corrugated Top sheets (color coded), or by the top row of holes being spaced 3 1/8” apart. The top sheet will also have a decal. 2. Apply the roll caulking (HS721) to the inside of the side wall sheets, (Vertical Seam) along each side the holes (except top sheet with 3 1/8” center holes, this caulk will be added on the roof panels). Be sure to caulk all seams along both sides of the holes to form a good seal and prevent leaking! 3. Place the caulked end over the un-caulked end of each adjacent hopper sheet. 4. Assemble ends with HS712 bin bolts and HS722 Hex Nuts (Hex nuts on inside of bin). Continue inserting Bin Bolts and Hex Nuts to all the holes along the vertical seam as you assemble the ring. Do not tighten until all sheets of each ring are assembled. Tighten Hex nuts Only! Tightening by the bolt head may result in seal failure. Sheet Gauge Color Chart 20ga Red 18ga Orange 16ga Blue 14ga Green 12ga Black 10ga Yellow Roll Caulking (HS721)
RkJQdWJsaXNoZXIy MTA3MzU=