Hog Slat Inc. Newton Grove, NC USA Sept. 2021 16 Feed Bins Legs 1. Assemble top and bottom Leg Base Plates to each leg. 2. The bin leg attaches to the (11) leg holes in the bottom ring. The bin legs with 23 holes will require the bottom two rings. 3. Align holes with Drift Pin from outside of bin. Hand tighten the HS712 Hex Bin Bolts and the HS722 Flange nuts on all holes. Keep bolt heads to the Inside of tank. 4. Roll the bin to assemble each leg until all the legs are complete. Tighten all nuts secure. 5. Before person exits bin, have them check for missing bolts by darkening bin and looking for light thru open holes. Leg
RkJQdWJsaXNoZXIy MTA3MzU=