Hog Slat Inc. Newton Grove, NC USA Sept. 2021 28 Feed Bins Erecting the Bin Before erecting your new bin, be sure all parts are assembled properly and hardware tightened securely. 1. Peel protective paper off decal before raising bin. 2. Cut 2” x 4” braces and fasten between legs as shown. 3. Raise the bin as shown below. Be sure to use appropriate equipment. • Be sure to use proper strength heavy equipment such as; crane, truck with hydraulic lift bed or other. • Level the legs, to assure stability, after the bin is raised. • Failure to adequately secure legs may result in damage to your Feed Bin. • Do not place bins in the immediate air flow from exhaust fans All bins shall have two Ground Connections. Ground Rod Clamps must be spaced equally around the bin. IMPORTANT! Make sure electrical equipment is properly installed and grounded by a qualified electrician according to the National Electrical Code. Bottom End View 2 x 4 brace
RkJQdWJsaXNoZXIy MTA3MzU=