Hog Slat Inc. Newton Grove, NC USA May 2024 6 Plastic Flooring System Installation of Plastic Flooring Procedure: 1. Starting in first row, interlock sections of plastic flooring slats behind each other. Position tabs as shown (Figure 7) and slide until tabs click into place (Figure 8). The flooring should be connected as depicted (Figure 9). Figure 7 Figure 8 Figure 9 2. Attach additional slats until desired length is reached. If necessary, cut the last slat of this row with a saw to meet the length. NOTE: Cuts should only be made in 6” increments on the cut channels shown below. 3. Place interlocked flooring slats on fiberglass beams. Make sure slat is even with end of beam. Using rubber hammer, tap flooring down securely onto beams.
RkJQdWJsaXNoZXIy MTA3MzU=