VANTEK CRP | NEWTON GROVE, NC | VANTEKCRP.COM APRIL 2024 Vantek warrants for a period of one (1) year that its products will be free of manufacturing defects and will be in conformity with published specifications when handled, stored, mixed, and applied in accordance with recommendations of Vantek. If any product fails to meet this warranty, the liability of Vantek will be limited to replacement of any non-conforming material if notice of such nonconformity is given to Vantek within (1) one year of delivery of materials. Vantek may in its discretion refund the price received by Vantek in lieu of replacing the material. No customer, distributor, or representative of Vantek is authorized to change or modify the published specifications of this warranty in any way. No one is authorized to make oral warranties on behalf of Vantek. In order to obtain replacement or refund the customer must provide written notice containing full details of the non-conformity. Vantek reserves the right to inspect the non-conforming material prior to replacement. EXCEPT FOR THE EXPRESSED WARRANTY STATED ABOVE, THERE ARE NO OTHER WARRANTIES, EXPRESSED OR IMPLIED, INCLUDING WITHOUT LIMITATION, ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR PURPOSE. VANTEK'S OBLIGATION SHALL NOT EXTEND BEYOND THE OBLIGATIONS EXPRESSLY UNDERTAKEN ABOVE AND VANTEK SHALL HAVE NO LIABILITY OR RESPONSIBILITY TO THE PURCHASER OR ANY THIRD PARTY FOR ANY LOSS, COST, EXPENSE, DAMAGE OR LIABILITY, WHETHER DIRECT OR INDIRECT, OR FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES. Limited Warranty VANTEK Concrete Restoration and Protection Vantek Acrylic Resin Concentrate Restrictions Restrict the use of the floor to light traffic and non-harsh chemicals until the mortar is fully cured. It is best to let the repair remain dry for the full cure cycle. Product Mixing For use as a bonding agent: Thoroughly blend ACRYLIC RESIN and water at a preconditioned temperature of approximately 70oF (21oC). ACRYLIC RESIN can be applied at temperatures of 45oF (7oC) and rising. Relative humidity must be below 85%. For use as an admixture: Thoroughly mix ACRYLIC RESIN and water at a preconditioned temperature of approximately 70oF (21oC). Add the ACRYLIC RESIN and water blend to the mixing device prior to adding selected mortar. Slowly add all of the mortar. Continue mixing for 3 to 5 minutes, or until a uniform lump-free mixture is attained. Avoid over-mixing, which could entrap air. With V-KRETE/VANTEK SLAT PATCH: 1 part ACRYLIC RESIN with 3 parts water for general repairs With cement, mortar, and stucco: 1 part ACRYLIC RESIN with 3 parts water Product Application When used as a bonding agent: Uniformly apply by roller, brush, or spray. Avoid puddling or run-off. If necessary, apply a second coat in order to maintain a wet surface prior to mortar placement. When used as an admixture: The surface must be saturated, but without standing water. Apply a prime coat of ACRYLIC RESIN and water mixed 1:2 with water prior to placement of the mortar mix. Then place and trowel apply the mortar to the desired finish. ACRYLIC RESIN is not required as an admix if the mortar will be coated with epoxy.
RkJQdWJsaXNoZXIy MTA3MzU=