Hog Slat Inc. Newton Grove, NC USA December 2022 9 Wind Storm Fans 7. Remove belt from hardware kit and install to capture pulleys and tension arm. THE BELT HAS A ROTATION DIRECTION. INSPECT BELT AND INSTALL SO ROTATION ARROWS TRAVEL COUNTER CLOCKWIRE WHEN LOOKING AT THE FAN FROM THE INTAKE! Once installed the belt tensioner should be located at notch 2 see image below. Assembly 1. Hold belt as shown in Figure. 2. Place end tab through two links at once and twist tab into place. 3. Bend back and insert second tab through end link by twisting tab 90° with thumb. 4. Ensure tab returns to position across belt. Reverse belt so tabs run inside. Installation 1. Turn belt with tabs to the inside before installing. 2. Determine direction of drive rotation. 3. Belt must travel following the belt direction arrow ( ) with tabs trailing. 4. Fit belt in nearest groove of smaller pulley. 5. Roll belt onto larger pulley, turning the drive slowly. Belt may seem very tight, this is okay. DO NOT JOG MOTOR. 6. Check to see all tabs are still in their correct position and are not twisted out of alignment. 7. For multiple belt drives, work belt from groove to groove. On particular wide drives, it may be easier to install half the belts from the inboard side and half from the outboard. Note: With drive ratios around 1:1, it may be necessary to add back one link to allow belts to be rolled on. This does not apply if using Alternate Installation Method.
RkJQdWJsaXNoZXIy MTA3MzU=