Hog Slat Inc. Newton Grove, NC USA August 2019 7 Wind Storm Fans Assembly 1. Remove packaging from fan and cone if applicable. • Locate hardware kit(s) and supplied literature and store for later use. • Ensure not to damage the fan or components during this step. 2. Remove shutter, guard, and top and bottom retainers. Place fan on its side being careful not to damage the mounting flanges. Install the top and bottom supports using supplied sheet metal screws (805057). The retainers should be parallel to the interior face of the fan housing. 3. Insert Housing assembly into framed opening and secure with #14 Stainless Sheet Metal screws (805060). (2) installers are required for this step. MOVE TO THE EXTERIOR OF THE HOUSE FOR THE NEXT STEP.
RkJQdWJsaXNoZXIy MTA3MzU=